Case Study · Textile Finishing
Stenter Frame Oven Burner for a Textile Finishing Line
An 8-zone stenter oven needed even heat to set fabric without curling edges. Baltur modulating burners with an integrated Dungs combo valve gave stable zone temperatures and saved gas.
The challenge
Uneven zone heat curled fabric edges and spoiled finish consistency.
The old two-stage burners could not track line-speed changes smoothly.
Gas-pressure dips tripped shutdowns and broke the finishing run.
Energy cost per metre was above target.
What we supplied & did
Fitted Baltur TBG120 modulating burners across the 8 stenter zones.
Used Dungs integrated combo valves to absorb upstream pressure dips.
Added pressure monitoring and Honeywell flame detection with interlock cutoff.
Tuned high/low-load curves on site to even each zone's hot-air band.
Measured results
What changed on the line
All eight zones hold even heat; edge curl and finish rejects dropped.
Modulating burners follow line-speed changes without hunting.
Combo valves absorbed pressure dips, ending unexplained shutdowns.
Gas use fell about 10% over the finishing campaign.
Equipment used in this project
Each category page covers what the part does, how it fails and what to check before ordering.
Running a similar duty?
Send the load, the fuel and the process profile — we come back with matching burner, controls and a safety train, and a quotation.
Request a QuoteKeep reading
Related solution
Textile Stenter
How Zhongli Weiye equips this industry — products, FAQs and a field-proven project.
View solution →